How to Read a River Gauge and What the Number Means
A river gauge reports the height of the water surface above a fixed reference point. That is all it reports. The number is not the depth of the river, it is not the amount of water in the river, and on its own it does not say whether a ship can sail. Read correctly, though, it is one of the most useful numbers in shipping, because a small set of published rules turns it into consequences: how deep the guaranteed channel is, how much a barge can load, which surcharge a carrier applies.
What the number is measured against
Every gauge has a zero. It is a fixed height, set when the gauge was installed or last surveyed, and it is chosen for convenience, not because it means anything about the river. The Rhine gauges published by the German waterways administration report centimetres above the gauge zero. The gauge zero itself sits at a stated height above sea level, and that height is published with the gauge. US gauges on the Mississippi report feet above the local gauge zero, and the National Weather Service publishes the zero’s elevation for many of them.
Because each gauge has its own zero, you cannot compare readings between gauges. A reading of 100 cm at one place and 100 cm at another are different water levels and probably different depths. You can compare a gauge with its own past, and you can compare it with the reference values published for that same gauge.
The reference values that give a reading meaning
A bare reading becomes useful next to a few published reference values for the same gauge:
- A low water reference. On the Rhine, the equivalent low water level, called GlW, is the reading below which low water conditions begin to matter for shipping. The explainer on GlW covers it in full.
- A published record. Authorities publish the lowest and highest levels ever recorded at a gauge. Recent readings are usually raw, so a new low can sit below the published record for a while before the authority validates it.
- Thresholds set by others. Carriers publish the readings at which they charge a surcharge or stop guaranteeing loading. The National Weather Service publishes flood stages and a low water threshold for many US gauges.
The gauge pages on this site list each of these beside the current reading, with a link to where it comes from.
Reading the trend, not just the level
A single reading tells you where the water is now. What shipping cares about is where it is going. A gauge that has fallen 20 centimetres in a week is a different story from one that has held steady at the same level for a month, even when today’s number is identical. The gauge pages show the change over 7 and 30 days, a chart of the last year with the published lines drawn on it, and the official forecast where the authority publishes one. Forecasts are the authority’s and are usually short, a few days on the Rhine.
Raw, provisional and validated values
Gauges measure continuously, often every 15 minutes, and the authority publishes those values almost immediately. Early values are unvalidated. A sensor can drift, ice or debris can affect a reading, and the authority may correct values later. This site labels every reading as raw, provisional or validated, shows its timestamp, and computes records only from the daily averages it has stored. When a recent low is below the published record, the page says so and says why.
What a gauge cannot tell you
A gauge is a single point on a long river. It says nothing about a shoal fifty kilometres upstream, about the width of the channel, or about weather that has not arrived yet. It also cannot tell you what a particular ship or a particular carrier will do. Navigation decisions belong to the skipper and the operator, using the authority’s own notices, which is why every page on this site carries the notice that it is informational and not for navigation.
How this site uses a reading
For each gauge, the site starts from the reading and its timestamp, then applies only published rules. Where the authority publishes a depth rule, the site shows the official fairway depth. Where a vessel’s draft can be estimated, the site shows an estimate and labels it as one. Where a carrier publishes a surcharge table, the site shows the band for the current reading with the carrier’s own link and date. Where none of that exists, the page says so instead of guessing. The methodology page lists every calculation.